Test Coupler...

New Low-Cost Dual Port Directional Coupler ( test coupler ) for FM Broadcast Transmitters regulated by Ofcom in the UK. Alternative to EME 7020/30B Directional Coupler for low power FM use.

Dual Directional Coupler

Every UK FM broadcast transmission system, from a few milliwatts to hundreds of kilowatts is required to have a Dual Directional Coupler installed. This is a regulatory requirement to allow system commissioning checks to be performed, and must also remain in place so that the measurements can be checked and compared again in the future.

The Ofcom Site Engineering Code for Analogue Radio Broadcast stipulates that the Coupler must have two (dual) ports, so that both Forward RF and Reflected RF parameters can be tested.

This low-cost Coupler is made in the UK by Lucoro Broadcast. It allows precise measurements to be made and uses quality parts to ensure continual service life and accuracy.

Get in touch...

GET IN TOUCH

If you have an enquiry, please fill-out the form and we will get back to you.

Lucoro on Facebook

FACEBOOK

See our latest posts on Facebook and don't forget to like us!

Lucoro on Twitter

TWITTER

Check out our latest Tweets and follow us to receive updates!

Support...

SUPPORT

Access to user manuals, firmware, software and useful product downloads.

ADDRESS

Clay Pit Lane
Bar Lane Industrial Est
Roecliffe
York
YO51 9FS
United Kingdom

+44 1423 313550

WHERE TO BUY

Buy direct from us, or through a distributor in your country.

COMPANY

Registered in England
No. 08349017

VAT No. GB153500641

© 2021 Lucoro Ltd
All rights reserved.

Privacy Policy